WIKA operating instructions, model CEP6000
MM/YYYY country code based on 10/2014 GB/CN
GB
For contact details, please see chapter 1 “General information” or the back
page of the operating instructions.
Faults Cause Measures
Low battery power, functioning
is only guaranteed for a short
period of time
Insert new alkaline batteries or
charged NiMH batteries
OL
-OL
Reading is significantly above
or
below the measuring range
Check: are the parameters
within the permissible
measuring range of the
calibrator
--> Match pressure or signal to
the permitted value
No display or
undefinable
characters,
instrument is not
responding to key
press
Battery empty Insert new alkaline batteries or
charged NiMH batteries
Mains operation without
battery: incorrect voltage/
polarity
Check/exchange power supply
unit
System error Switch off the instrument,
wait for a short period of time,
switch on again
Instrument faulty Send instrument in for repair
7. Faults
To Next Page
Loading...