Will Burt POSITIONIT MM233TX2TXRX2 - Installation Tools; Components; Unpacking; Table 2-1 Tools and Materials Recommended for Installation

POSITIONIT POSITIONERS
2-2 PM-01011-A
October 2023
2.2 Installation Tools
Table 2-1 lists tools and materials recommended for installation.
Table 2-1 Tools and Materials Recommended for Installation
Tools and Materials
Safety Glasses
Safety Gloves
Safety Shoes or Combat
Boots
Hard Hat or Helmet
Wrenches
Screwdrivers
Wire Cutter / Stripper
Crimping Tools
Mounting Hardware (Payload)
Level
Soldering Kit
Mounting Hardware (Pedestal)
Thread-Locking Compound or Locking Hardware
2.3 Components
When unpacking, check to ensure all ordered components have arrived. The components
your system includes will vary based upon your order.
Possible components include:
• Positioner (PI-35, PI-75 or PI-150)
• Controller
• Controller Manual (ships with controller)
• PositionIt Positioner Operator’s Manual (this manual)
• Power/Data Cable (used to connect positioner to the controller and the power supply)
• Some combination of the following:
o Positioner Power Supply (used in systems with AC input power)
o Step Up Converter (used in systems with 12 VDC input power)
o Step Down Converter (used in systems with 24 VDC input power)
• Barrel Connector (2.1 mm) (used to connect the controller to the power supply)
2.4 Unpacking
Unpack as follows:
1. Carefully open the box(es) and unpack all components.
2. Check for any damage from shipping. If damage has occurred, notify the carrier.
3. Ensure that all required tools are readily available.