Will Burt POSITIONIT MM233TX2TXRX2 - Restore Limit Stops with the Keyboard; Unstowing the Positioner; Table 3-3 Default Limit Stop Numbers

POSITIONIT POSITIONERS
PM-01011-A 3-11
October 2023
3.3.8.2 Restore Limit Stops with the Keyboard
To restore the electronic limit stops to factory settings with the keyboard:
1. Press [Set].
2. Press [N] where “N” represents the number which corresponds to the preset being
restored. Reference Table 3-3 to determine which number to use to change each
electronic limit stop.
Table 3-3 Default Limit Stop Numbers
Store Preset
Function
70
Restores default counterclockwise limit
71
Restores default clockwise limit
72
Restores default up limit
73
Restores default down limit
3. Press [Pre]. The electronic limit has been adjusted back to the factory default.
3.4 Unstowing the Positioner
The customer must set preset position [2] before this function can be used.
To unstow the positioner:
1. Power on the system.
2. Perform the pre-operation check (Section 3.1).
3. Press [2].
4. Press [Pre]. The positioner will move to the preset unstowed position. When moving
to the unstowed position, the positioner will first tilt and then pan. As the positioner
nears the unstowed position, it will slow down. If an emergency stop is required as
the positioner is moving to position, move the joystick to cancel out the command.
The system is unstowed and ready for use.