Will Burt POSITIONIT MM233TX2TXRX2 - Restoring Factory Defaults; Camid; Monid; Figure 5-1 Start up Screen

POSITIONIT POSITIONERS
PM-01011-A 5-3
October 2023
5.2 Restoring Factory Defaults
The system is designed to function using the factory defaults shown in Figure 5-1. These
settings will display when the controller is powered on. If these defaults are changed, the
system may not function properly. There is no single key or command sequence to reset all
factory settings.
CamID: 001
MonID: 001
Protocol:
Pelco-d
Baudrate:
2400
Figure 5-1 Start Up Screen
To reset these settings proceed as follows:
5.2.1 CamID
When the controller is powered on, the CamID will be displayed. The CamID should be 001.
If necessary, reset the CamID to 001. To reset the CamID:
1. From the start up screen (Figure 5-1), press [1].
2. Press [Cam]. The CamID will change to 001. The setting is saved.
5.2.2 MonID
When the controller is powered on, the MonID will be displayed. The MonID should be 001.
If necessary, reset the MonID to 001. To reset the MonID:
1. From the start up screen (Figure 5-1), press [1].
2. Press [Mon]. The MonID will change to 001. The setting is saved.