Wirepath WPS-365-DVR - Alarm

101
WPS-365-DVR-9CH & 16CH Installation and Users Manual
 •LOG
By default, the DVR will log when video loss is detected to the Event Log.
 •E-MAIL
This DVR can send an email message to a predened email address in the event video loss is detected for
this camera. The default setting is disabled. See Section 9.3.13 for more information on e-mail.
 •FTP
This DVR can send the recorded video loss event for this camera to a FTP server. The default setting
is disabled.
 •SCREENMESSAGE
By default, the DVR will display a video loss message in the System Status Bar (visible from the VGA
or BNC main monitor output only) when video loss is detected for this camera.
9.3.9. ALARM
The Alarm Setup allows the administrator to dene the attributes for each alarm input and the actions if it
is triggered. Up to sixteen alarm inputs such as motion detectors or door contacts that can be connected
to the DVR.
Thefollowingisabriefdescriptionforeachiteminthismenuanditsspecicoperations:
 •ALARM
Non-congurable eld indicates the Alarm Input being congured.
 •NORMALSTATE
Select N/A, Close or Open. The type of sensor connected to the DVR will determine the setting. For
example, motion detectors typically are normally open while door contacts are normally closed. Select
N/A (Not Available) if the input is not used and the following items will not be adjustable. The default setting
is Open.
 •TITLE
Friendly name of alarm channel reported to the system log and Notications.
 •DELAY
This feature has no function for this model of DVR.