Wirepath WPS-365-DVR - Factory Default

62
WPS-365-DVR-9CH & 16CH Installation and Users Manual
levels of QCIF (Fair is the lowest quality while Superne is the highest quality). If Video Streaming is used, the
total system recording rate will be reduced.
NOTE:TouseVideoStreaminginInternetExplorer,theusermustselecttheExtra VideoStream option in the
Modify Menu of the Device List(SeeSection 9.2.8.1).
- QCIF Fair – Lowest QCIF Resolution
- QCIF Normal – Medium QCIF Resolution
- QCIF Fine – High QCIF Resolution
  -QCIFSuperne–Best QCIF Resolution
 •VIDEOSTREAMQUALITY
Sets the level of data compression when the Video Stream Resolution is set to anything other than Record.
6.12. FACTORY DEFAULT
To reset all the DVR settings to factory default values, press ▲▼◄► on the front panel of the DVR or on the
remote control to change the highlighted option to Factory Default and then press ENTER. Alternatively use
the mouse to select Factory Default. Once selected, a conrmation dialog will be shown, press ENTER again to
make the changes. Or select ESC, or right-click the mouse to exit without resetting the DVR.
WARNING: All settings will be lost and replaced with factory default settings.
Settings cannot be recovered after a Factory Default.