Wirepath WPS-365-DVR - Page 32

32
WPS-365-DVR-9CH & 16CH Installation and Users Manual
•GOTOPRESET
The GOTO Preset feature works in conjunction with the Camera To Go setting and denes the
preset position the Camera To Go PTZ camera will go to when video signal is lost for this camera.
For more details about preset positions for PTZ cameras, refer to Section 7.
 •PRE-RECORD
Pre-Record denes how much time the DVR will record before video loss is detected. The Pre Record FPS
set in Section 6.2 determines the frame rate of this recording. Press +/- buttons on the front panel of the
DVR or the remote control to adjust the value from 0 to 10 seconds. Alternatively use the mouse to adjust
this setting.
Notethattheactualpre-recordtimemaybeshorterthanthevaluesetifthetotalsizeofthepre-record
  videoexceedsthepre-recordvideobuffer.
 •ALARMOUT
Dene which Alarm Output will be triggered when video loss for this camera is detected. Press +/-
buttons to select N/A for none or either of the Alarm Outputs (1 for NC or 2 for NO).
 •BUZZER
By default, the internal buzzer is enabled to sound when video loss for the camera is detected.
Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively use the mouse
to left-click on this item.
• LOG
By default, the DVR will log when video loss is detected to the Event Log (see Section 8.2). Highlight
this setting and press ENTER or +/- to enable or disable this item. Alternatively use the mouse to
left-click on this item.
 •SCREENMESSAGE
By default, the DVR will display a video loss message in the System Status Bar when video loss is detected
for this camera. Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively
use the mouse to left-click on this item.
 •E-MAIL
This DVR can send an email message to a predened email address in the event video loss is detected
for this camera. Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively
use the mouse to left-click on this item. The default setting is disabled. See Section 6.11.1 for more
information on e-mail.
 •FTP
This DVR can send the recorded video loss event for this camera to a FTP server. Highlight this setting
and press ENTER or +/- to enable or disable this item. Alternatively use the mouse to left-click on this
item. The default setting is disabled.