Wirepath WPS-365-DVR - Page 39

39
WPS-365-DVR-9CH & 16CH Installation and Users Manual
To navigate and operate this menu:
 •▲▼◄►
Press these buttons on the front panel of the DVR or remote control to select an item. Alternatively use
the mouse to select an item.
 •ESC
Press the ESC button on the front panel of the DVR or remote control to escape from this menu and
return to the main menu. Alternatively use the mouse to exit the sub menu by clicking on the “X.” If
the contents in this menu have been modied, a Save dialog box will be displayed requesting the user
to save the changes. Press ENTER on the front panel of the DVR or remote control to exit and save, ESC
to exit without saving. Another method to escape is to use the mouse to “right-click,” and exit the sub
menu.
Thefollowingisabriefdescriptionforeachiteminthesubmenuanditsspecicoperations:
 •TOTALPAGES
Set Total Pages included in this SEQ Display Type. Press +/- buttons on the front panel of the DVR or the
remote control to select the desired number from the available list. Alternatively use the mouse to select
the appropriate number.
 •DWELLTIME
Set the Dwell Time (how long this page will be displayed before transitioning to the next page) from 3 to
60 seconds. Press +/- buttons on the front panel of the DVR or remote control to change this value.
Alternatively use the mouse to select the appropriate time.
 •SETTINGS
Enter the Settings window to set the camera in each window for each page of this SEQ Display Type.
Press ENTER on the front panel of the DVR or on the remote control to display settings page as shown.
Alternatively left-click on the Settings button to enter this window.
•MAIN DISPLAY TYPE
Determines the camera channel conguration of the Main Display. In 'Default' the channel conguration
follows a normal standard (i.e. 1w - Page1 = Camera 1, Page2 = Camera 2, etc. 4w - Page1 = 1/2/3/4,
Page2 = Camera 5/6/7/8, etc. 7w - Page1 = Camera 1/2/3/4/5/6/7, etc.) In 'SEQ' the channel conguration
follows the layout of the Sequence menu, where a camera can be placed on any channel number.
•MAIN DISPLAY CALLED BY EVENT
Allows the Main Monitor output to show a single camera full screen view when that channel is triggered by
motion or alarm.