Wood-mizer LX50 G14S - Sawmill Operation; Safety Instructions; Sawmill Setup; Replacing the Blade

Table of Contents Section-page
Table of Contents SW-07doc0722215
2.12 Clutch Lever Installation (Gas Sawmills) ............................................2-32
SECTION 3 SAWMILL OPERATION 3-1
3.1 Safety Instructions..................................................................................3-1
3.2 Sawmill Setup.........................................................................................3-1
3.3 Replacing the Blade................................................................................3-3
3.4 Tensioning the Blade..............................................................................3-4
3.5 Tracking the Blade .................................................................................3-5
3.6 Horizontal Adjustment of Idle-Side Blade Wheel..................................3-6
3.7 Motor Drive Pulley Alignment..............................................................3-7
3.8 Horizontal Adjustment of Drive-Side Blade Wheel...............................3-7
3.9 Vertical Adjustment of Drive-Side Blade Wheel...................................3-8
3.10 Vertical Adjustment of Idle-Side Blade Wheel....................................3-11
3.11 Saw Head Adjustment ..........................................................................3-13
3.12 Blade Deflection...................................................................................3-14
3.13 Blade Guide Vertical Adjustment ........................................................3-15
3.14 Blade Guide Spacing Adjustment .......................................................3-16
3.15 Blade Guide Horizontal Adjustment ....................................................3-18
3.16 Blade Height Scale Adjustment............................................................3-19
3.17 Engine/Motor Drive Belt Adjustment ..................................................3-20
3.18 Starting the Engine/Motor ....................................................................3-21
3.19 Loading, Turning and Clamping Logs .................................................3-22
3.20 Up/Down Operation .............................................................................3-24
3.21 Blade Drive Operation..........................................................................3-24
3.22 Gas Engine Operation (G14) ................................................................3-26
3.23 Feed Operation .....................................................................................3-28
3.24 Cutting the Log.....................................................................................3-29
3.25 Edging...................................................................................................3-30
3.26 Blade Height Scale ...............................................................................3-30
3.27 Stop Bolt Adjustment ...........................................................................3-31
3.28 Water Lube System ..............................................................................3-32
3.29 Transporting the Sawmill .....................................................................3-33
3.30 Troubleshooting....................................................................................3-34
SECTION 4 MAINTENANCE 4-1
4.1 Maintenance Performed as Needed........................................................4-1
Mast Track, Rollers and Wipers
4.2 General Maintenance..............................................................................4-2
Every 8 Hours of Sawmill Operation
4.3 Motor/Engine Maintenance....................................................................4-4