Sawmill Operation
Up/Down Operation
Sawmill Operation doc072221 3-24
3
3.20 Up/Down Operation
1. Install a blade, if needed, and check for correct blade tension.
2. Using the crank handle, set the saw head to the desired height (the blade height scale shows the
height of the blade above bed rails). One full turn of the crank handle moves the saw head
12.21 mm. If you rotate the crank handle by one tooth on the disc, the saw head will be
raised/lowered 0.18 mm.
See Figure 3-21. Use the crank handle to raise or lower the saw head.
CAUTION! DO NOT try to force the saw head above the 50 cm mark
or below the 2.54 cm mark. Damage to the up/down system may
result.
3.21 Blade Drive Operation
DANGER! Make sure all guards and covers are in place and
secured/closed before operating the sawmill. Failure to do so may
result in serious injury.
Be sure the blade housing cover is closed and secured before starting the engine or motor. Use the
rubber latches to fasten the blade housing cover shut. If the blade housing cover is not closed and
secured, the safety switch located on it makes starting the motor/engine impossible. If you open the
cover during sawmill operation, the blade engine/motor will be stopped.
FIG. 3-21
Use crank handle to change saw head height
To Next Page
Loading...
