Wood-mizer LX50 G14S - Horizontal Adjustment of Idle-Side Blade Wheel

Sawmill Operation
Horizontal Adjustment of Idle-Side Blade Wheel
Sawmill Operation doc072221 3-6
3
3.6 Horizontal Adjustment of Idle-Side Blade Wheel
First, adjust the idle-side blade wheel horizontally. To do this, loosen the set nuts on the adjustment
bolts and tilt the blade wheel until it is properly aligned.
See Figure 3-3. The bolt for adjusting the idle-side blade wheel is shown below.
If the blade is too far out, back the blade onto the wheel by turning the cant control bolt left. If the
blade is too far in, turn the cant control right until the gullet of the blade is the correct distance from
the front edge of the wheel.
FIG. 3-3
Cant Control Bolt