SAWMILL ASSEMBLY
Water Bottle Installation
2
2-28 15doc032021 SAWMILL ASSEMBLY
2.9 Water Bottle Installation
1. Install the water bottle tray to the mast cross tube using the M8x70 bolts. Before bolting, place a
cable clamp on one of the hex head bolts.
2. Slide the rubber water tube onto the water bottle pipe fitting. Place the other end of the water tube
on the fitting located on the blade guide.
See figure 2-14.
See figure 2-13.
FIG. 2-13
FIG. 2-14
To Next Page
Loading...
