Woodward EGCP-2 - Page 108

EGCP-2 Engine Generator Control Package Manual 26174
98 Woodward
Raise Rate
 Rate, in %/s, at which the process reference will change when the EGCP-2
receives a Raise Load input (Discrete Input #6) or Modbus address
AW40328 while operating in process control mode.
Lower Rate
 Rate, in %/s, at which the process reference will change when the EGCP-2
receives a Lower Load input (Discrete Input #7) or Modbus address
AW40328 while operating in process control mode.
Process High Limit
 Maximum allowable process reference level.
 Dependent on Process Units setting.
 Effective on active master unit only.
Process High Limit Alarm
 Sets Alarm Action when process High Limit is reached.
Process Low Limit
 Minimum allowable process reference level.
 Dependent on Process Units setting.
 Effective on active master unit only.
Process Low Limit Alarm
 Sets Alarm Action when process reference reaches the Low Limit.
Process Units
 Allows user to configure Process Input values to be displayed in other units
besides milliamps or voltage.
o The KW Transducer signal will still be in milliamps or volts.
 This selection effects Process Configurations:
o Process Reference
o Process High Limit
o Process Low Limit
o Process High Value
o Process Low Value
 Status screens effected
o Discrete I/O
o KW Load