EGCP-2 Engine Generator Control Package Manual 26174
4 Woodward
Hardware
The EGCP-2 is an integrated control package. All control hardware is contained
in one compact enclosure.
Figure 2-1 is a physical outline drawing with dimensions of the EGCP-2 for
reference during the construction of mounting panels, etc.
To mount the EGCP-2 panel use type M5 x 12mm thread forming screws
(Woodward part number 1029-529). Eight mounting screws are shipped with
each control.
When mounting into an enclosure, make sure the enclosure is vented
to atmosphere through a Type 4 vent tube or unsealed conduit.
Environmental Specification
Temperature Range around outside
of EGCP-2 Chassis –20 to +70 °C — Operating
Relative Humidity 95% non-condensing at 20 to 55 °C
Physical Specification
Enclosure Size 282 x 358 x 69 mm
11.1 x 14.1 x 2.7 inch
Accessories
Components needed for installation and remote communication. These items do
not ship with the 8406-120 and 8406-121 part numbers—they must be ordered
separately.
8928-301—EGCP-2 connector kit. Contains all of the mating terminal blocks
for the EGCP-2. See Appendix A for mating connector information.
5417-551—Communication Cable for RS422. This cable will connect your
PC to the EGCP-2 RS422 port. This is a point-to-point connection. It can be
used with EGCP-2 software tools. Communication Manual 26181 contains
the software tool information.
To Next Page
Loading...
