wsm m9540 - ROPS Removal

L3-S7
M9540Low Profile, WSM
TRANSMISSION
[2] ROPS
ROPS Upper Frame
1. Hook the upper frame (1).
2. Remove the damper mounting nut (2).
3. Remove the lunch pin (5) and set bolt (4).
4. Remove the upper frame (1) using a hoist.
5. Remove the external position control rod (6).
6. Remove the lift rod (7) and lower link (8).
W1012812
Rear Wheel and Front Axle Rocking Restrictor
1. Place the disassembling stand under the transmission case.
2. Install the front axle rocking restrictor (1). (Refer to “8. SPECIAL
TOOLS” at “G.GENERAL” section.)
3. Remove the rear wheel.
(When reassembling)
W1012997
(1) Upper Frame
(2) Nut
(3) Damper
(4) Set Bolt
(5) Lynch Pin
(6) External Position Control Rod
(7) Lift Rod
(8) Lower Link
Tightening torque Rear wheel mounting nut
343.2 to 393.3 N·m
35.0 to 40.1 kgf·m
253.2 to 290.0 lbf·ft
(1) Front Axle Rocking Restrictor
KiSC issued 09, 2008 A