Ci7XX0 BENCHTOP SPECTROPHOTOMETER
44
System Repacking Instructions
Refer to the following instructions to repack your system in the event shipment is required. If the
original carton and packing materials are not available, contact X-Rite to have a replacement
shipped to your location.
Items to repackage with original shipped instrument:
• Original box and foam packaging (including large instrument bag)
• Aperture plates
• Black trap
• Sample holder
• Sample shelf (w/ thumb screws)
• Power line cord
• USB cable
• White calibration standard
• Green calibration standard
• UV calibration standard
• Black rubber shim
Repackaging Instructions:
1. Repackage contents of Transmission Kit (if installed)
a. Remove any transmission components from the inside of the instrument.
b. Place all transmission kit components into the original transmission case.
2. Prepare instrument for repackaging
a. Lock instrument optics for shipment.
i. Power on your instrument and connect to PC via USB.
ii. Insert the “Ci7XX0 Benchtop Spectrophotometer” CD into your optical drive. If
the main startup menu does not automatically launch, run the “start.exe”
program from the Setup Tool folder of the CD.
iii. Select “Setup Tool” from under the “Utilities” section of the software CD main
menu. Run the Setup program.
iv. Select “Lock Optics” from the main menu of the Setup program. (You can hear
the instrument position the optics into the safe transport position.)
v. Close the Setup program after the instrument optics has completed movement
into a position that is safe for transport.
vi. Power off the instrument using the rear power switch.
vii. Remove the CD from the optical drive and place into the envelope.
b. Disconnect and package the power line cord and USB cable.
i. Fold the power cord and place into the bubble bag (if available from original
packaging).
ii. Fold the USB cable and place into the plastic bag (if available from original
packaging).
c. Package the instrument sample holder arm.
i. Loosen each screw using a flat blade screwdriver or T25 Torx wrench.
ii. Place sample holder arm into the bubble bag and seal (if available from original
packaging).
To Next Page
Loading...
