Selecting
Resolution
QMS 3825/3225/2025 Users Guide2-18
image your printer can make, so you will select the higher setting.
Many applications allow you to change resolution on a per job basis.
Use the control panel only if you want to change the default.
The higher setting is the default value. To change the resolution
1 Press the Online/Offline key to take the printer off line.
The indicator light by the key goes out and the message window
continues to display
IDLE
or
ENERGY SAVER
2 Press the Menu key to enter the configuration menu.
The message window displays
CONFIGURATION
OPERATOR CONTROL
3 Press the Select key to enter the menu. Press the Next key
until the message window displays
CONFIGURATION
ADMINISTRATION
4 Press the Select key. Press the Next key until the message
window displays
ADMINISTRATION
ENGINE
5 Press the Select key. Press the Next key until the message
window displays
ENGINE
DEF. RESOLUTION
6 Press the Select key.
On a 3825 Print System, the message window displays
DEF. RESOLUTION
*600 DPI
To Next Page
Loading...
