8825/8830 DDS User Guide/52
Special features and making special copies
Adjusting the Margins
−
Margin Key (continued)
Margins
The MARGINS selection allows the operator to select the dimensions for
each area shown on the screen.
If the MARGINS MENU is not already displayed, press the Margins key.
Press the Next key or the Previous key to select MARGINS, then press the
Enter key to confirm the choice.
If the unit of measure has been set to MILLIMETERS (refer to the
References
section for instructions), then (MM) appears next to each value.
If INCHES has been set, then (IN) appears. Press the Next key or the
Previous key to select a margin, then press the Enter key to adjust the
values.
Press the Next key to select the +/- field. The +/- field becomes highlighted,
and scroll arrows appear, indicating that a choice may be made. Press the
Next key to select either “+” or “-“. Press the Enter key to confirm the
choice.
MARGINS MENU
JUSTIFICATION
MARGINS
Scanner
Left image edge
Right image edge
Trail edge
Lead edge
To Next Page
Loading...
Need help?
General
