8825/8830 DDS User Guide/85
Reference
Scanner Diagnostics (continued)
Full System Test
The FULL SYSTEM TEST checks the control electronics in the Scanner.
To test the control electronics, select FULL SYSTEM TEST from the
SCANNER DIAGNOSTICS MENU.
The FULL SYSTEM TEST screen is displayed.
Each letter corresponds to a test, identified in the table to the right.
While a subtest is in progress, an R is displayed to the right of the test letter.
If the subtest is successful, a P is displayed
If a subtest fails, an F will be displayed. If an F is displayed, call for service.
Note: the test sequence will be executed until the operator presses the Exit
key, or until all subtests are completed.
The Memory Tests (J) are the same tests as those executed when
MEMORY TESTS is selected from the SCANNER DIAGNOSTICS menu. In
this case, a global pass or fail result is reported. If you wish an explicit report
on each memory test, use the MEMORY TESTS selection instead of the
FULL SYSTEM TEST selection.
FULL SYSTEM TEST
A) B) C) D) E) F)
G) H) I) J) K)
PRESS START TO BEGIN
To Next Page
Loading...
Need help?
General
