LOADING PAPER IN TRAYS 3 AND 4 OF THE TANDEM TRAY
The Tandem Tray Module holds larger amounts of paper for fewer printing interruptions. It contains three trays.
Tray 2 holds paper sizes up to SRA3/12 x 18 in. Trays 3 and 4 hold A4-size (210 x 297 mm), Letter-size (8.5 x 11 in.),
JIS B5-size (182 x 257 mm), or Executive-size (7.25 x 10.5 in.) paper only.
The control panel displays a warning message when the paper in the tray is in short supply, or when a tray is empty.
To change the paper size, refer to Configuring Trays 3 and 4 of the Tandem Tray Module.
To load Tray 2, refer to Loading Paper in Trays 1–4.
1. Pull Tray 3 or Tray 4 out until it stops. Wait for the tray to lower and stop.
2. The control panel displays the paper tray settings. Ensure that you load the correct paper type.
Note: Do not load custom-size paper into Tray 3 or Tray 4 of the Tandem Tray Module.
3. Fan the edges of the paper before loading it into the paper trays. This procedure separates any sheets of paper
that are stuck together and reduces the possibility of paper jams.
Note: To avoid paper jams and misfeeds, do not remove paper from its packaging until necessary.
4. Stack the paper against the left rear corner of the tray as shown.
• Insert letterhead and pre-printed paper face down with the top edge toward the front of the tray.
• Load hole-punched paper with the holes to the left.
Note: Do not load paper above the maximum fill line. Overfilling the tray can cause the printer to jam.
5. Close the tray.
192
Xerox
®
EC8036/EC8056 Color Multifunction Printer User Guide
Paper and Media
To Next Page
Loading...
