User Guide 3-1
3. Scanner Setup
1. Remove the scanner from the shipping box, verify all parts listed on What’s in the Box are in
the box. We recommend that you keep the original packing materials in case you need them
later.
2. Remove any shipping tape from the scanner as indicated in the following illustration(s).
The above illustrations are for example purposes only. Your scanner’s packaging may vary slightly.
3. Hold the ADF Paper Tray and insert two pins to the holes on the top of the scanner as shown.
Connect the Scanner Power Cord
Note: Only use the power supply included with your scanner. Connecting any other type of power
supply may damage your scanner, and will void its warranty.
1. Select the appropriate power cord for your country.
2. Plug the power supply into the power port on the scanner.
To Next Page
Loading...
