Maintenance Xerox
®
N60w Scanner
User Guide 16-3
Power Settings
• Sleep mode—sleep mode is the low-power state when the scanner is not in use. You can
adjust the amount of time you want the scanner to wait before it goes into low power.
Click the green enter button to save any changes in the Sleep mode field.
Click the red reset button to reset to the default timeout value.
• Power off—input the number of minutes you want the scanner to wait before it turns itself
off.
Click the green enter button to save any changes in the power off field.
Click the red reset button to reset to the default timeout value.
• USB off— by default the value is set to match Sleep mode. This temporarily turns off the
functionality of the USB ports until the scanner is woken up by pressing a button or placing
paper in the ADF. This aids to reduce unnecessary power consumption.
Note: LAN and WiFi will continue functioning
Scanner Configuration
• Counters—click the reset button next to the counter you want to set back to 0.
• Show maintenance reminders—select this option be notified when it is time to clean or
replace the rollers. After cleaning or replacing the rollers, click the reset button next to the
roller counters in this screen.
Driver Settings
The options in this panel are for configuring how the TWAIN interface will behave in some
scenarios. Please see the TWAIN scanning guide for instructions.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
