1Welcome
Xerox Phaser 3635 User Guide 9
will only fit into an earthed electrical outlet. This is a safety feature. If you are
unable to insert the plug into the outlet, contact a licensed electrician to
replace the outlet.
2. Always connect equipment to a correctly grounded power outlet. If in doubt,
have the outlet checked by a qualified electrician.
Disconnect Device
The power cable is the disconnect device for this equipment. It is attached to the
back of the machine as a plug-in device. To remove all electrical power from the
equipment, disconnect the power cable from the electrical outlet.
Emergency Power Off
If any of the following conditions occur, turn off the machine immediately and
disconnect the power cable(s) from the electrical outlet(s). Contact an authorized
Xerox Service Representative to correct the problem:
The equipment emits unusual odours or makes unusual noises.
The power cable is damaged or frayed.
A wall panel circuit breaker, fuse, or other safety device has been tripped.
Liquid is spilled into the machine.
The machine is exposed to water.
Any part of the machine is damaged
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose
of used batteries according to the instruction.
Quality Standards
The product is manufactured under a registered ISO9002 Quality system.
If you need additional safety information concerning this XEROX product or
XEROX supplied materials you may call the following number:
EUROPE: +44 (0) 1707 353434
USA/CANADA: 1 800 928 6571
Safety Standards
EUROPE: This XEROX product is certified by the following Agency using the Safety
Standards listed.
Agency: TUV Rheinland
Standard: IEC60950-1, 2001
USA/CANADA: This XEROX product is certified by the following Agency using the
Safety Standards listed.
Agency: UNDERWRITERS LABORATORIES
To Next Page
Loading...
Need help?
General
