4.1.1 Control Console (OPE)
1. Remove Corner Covers by pushing up
end of Corner Cover slightly with large
flat blade screwdriver (1) and then
rotate screwdriver (2) to release the
snap-fit (red arrow).
2. Pull Corner Cover toward front to
remove cover.
3. Remove other Corner Cover.
4. CAUTION Harnesses must be
disconnected after lifting Control
Console.
Remove Control Console by removing
Screws (2, upper arrows), lifting Control
Console to disengage mounts on each
side (lower arrows), bending side
covers out to move front of Control
Console up and disengage mounts
along rear edge. Disconnect
connectors (2) but leave battery
connected.
To Next Page
Loading...
