Problem
Fold Adjustment
Suggested Solutions
Tip
The Finisher - Fold Adjust Position is available only when the system configuration includes
one of the following:
• Production Ready (PR) Booklet Maker Finisher (for Bi-Fold / Single-Fold), or
• Optional C/Z Folder with one of the following optional finishers:
- PR Finisher, or
- PR Booklet Maker Finisher, or
- PR Finisher Plus
For detailed information about these finishing devices, refer to the Optional Devices Guide for
Xerox
®
Versant
®
180 Press.
Create and/or use an existing Finisher - Fold Adjust Position.
Note
Before creating a new or using an existing profile or performing any alignment adjustments,
read / review the entire Fold Adjustment Profile section in the System Administration Guide.
• Depending on your system configuration, the following fold adjustments are available:
- Bi-Fold Single Sheet (available only with the PR Booklet Maker Finisher)
- Bi-Fold Multiple Sheets (available only with the PR Booklet Maker Finisher)
- Bi-Fold Multiple Sheets Stapled (available only with the PR Booklet Maker Finisher)
- C-Fold (available with the optional C/Z Folder)
- Z-Fold (available with the optional C/Z Folder)
- Z-Fold Half-Sheet (available with the optional C/Z Folder)
Create a new or use an existing Finisher - Fold Adjust Position. The following is a summary of
the steps required for creating a new or using an existing procedure.
Note
This option is accessed from Machine Status > Tools > Setup & Adjustment > Finisher - Fold
Adjust Position.
1. From the Fold Adjustment tab, select either the New or Edit button.
If you are editing an existing fold adjustment, select Machine Status > Tools > Setup &
Adjustment > Custom Paper Settings. Select the desired Custom Paper > Change Set-
tings > Adjust Fold Position > Change Settings.
2. Type in a new name, or if desired, edit the existing name.
3. To complete the procedure, refer to System Administration Guide, the, Fold Adjustment
Profile section. .
Xerox
®
Versant
®
180 Press6-18
User Guide
Troubleshooting
To Next Page
Loading...
