Problem
Smear 208 mm from the Lead Edge
Suggested Solutions
1. Confirm the media being used is compatible with the press, is within supported specifica-
tions, and in good condition.
2. Change the Adjust Paper Speed at Transfer Module setting.
• Use this feature to adjust the paper speed in the transfer unit.
• The option can be found in Machine Status > Tools > Setup & Adjustment > Custom
Paper Settings. Select the desired Custom Paper > Change Settings > Adjust Paper
Speed at Transfer Module > Change Settings.
• Based on the output, decrease Adjust Paper Speed at Transfer Module in increments
of 0.05%. After every increment adjustment run test prints and evaluate the output to
determine if additional adjustment is necessary.
• Transfer defects may occur when paper speed is too fast or too slow.
3. Change the Adjust Fusing Speed setting.
• This feature can be used to correct the issue of a smear at 208 mm from the Lead Edge
(LE). Increase the fuser speed to correct the issue.
• This feature also impacts print quality.
- Increasing fuser speed extends the image. If fuser speed is set too high it may
cause paper jams.
- Decreasing fuser speed shrinks the image.
• The option can be found in Machine Status > Tools > Setup & Adjustment > Custom
Paper Settings. Select the desired Custom Paper > Change Settings > Adjust Fusing
Speed > Change Settings.
• Increase fuser speed in increments of 0.5%. After every increment adjustment run test
prints and evaluate the output to determine if additional adjustment is necessary.
Problem
Trail Edge Deletions
Suggested Solutions
Change the Adjust Image Transfer for Trail Edge setting.
• This feature is used to adjust the voltage ratio on the Secondary Bias Transfer Roll (BTR),
where the image is transferred from the belt to the paper.
• This feature can be found in Machine Status > Tools > Setup & Adjustment > Custom
Paper Settings. Select the desired Custom Paper > Change Settings > Adjust Image
Transfer for Trail Edge > Change Settings.
• Decrease the Adjust Image Transfer for Trail Edge in increments of 5 to 10%. After every
increment adjustment run test prints and evaluate the output to determine if additional
adjustment is necessary.
6-19Xerox
®
Versant
®
180 Press
User Guide
Troubleshooting
To Next Page
Loading...
