Wireless Array
Installing the Wireless Array 71
Array/AP Management Interfaces
User Interfaces (CLI, WMI)
With zero-touch setup provided by XMS and Mobilize, your Xirrus network is
ready for use a few minutes after deployment. We recommend that you use the
Xirrus Management System (XMS) for ongoing monitoring and fine-tuning of the
network.
Should you wish to check the configuration of individual Arrays locally, Array
settings may be viewed or configured through the Command Line Interface (CLI)
using SSH, or on a browser with the Web Management Interface (WMI). You may
use the CLI via the serial management port (console—on all Arrays except the
XR-500/600/1000 Series and some XR-2000 models) or any of the Gigabit
Ethernet ports. You can use the WMI via any of the Array’s Ethernet ports.
ArrayXMS
Figure 32. Network Interface Ports—XR-520 (left); XR-1000 Series (right)
Figure 33. Network Interface Ports—XR-600 Series
To Next Page
Loading...
Need help?
General
