Wireless Array
Installing the Wireless Array 75
The Array’s license determines some of the features that are available on the
Array. For example, the Application Control feature on XR Arrays requires a
license. The Array’s license is not installed at the factory. The Array must have a
license before providing wireless service.
If you need to enter the license manually, use the following procedure. It describes
entering the license key using the WMI. If you are using the Xirrus Management
System (XMS), you may use it to manage and upgrade large numbers of licenses
for the wireless network.
1. This procedure assumes that you have pointed a browser to the Array to
start WMI, and that you have logged in with the default username and
password above.
2. In the left hand frame, in the Configuration section, click Express Setup.
3. License Key: Enter the key that was provided for the Array. The key was
provided to you in an email as an attachment in the form of an Excel file
(.xls). Enter the key exactly as it appears in the file. Click the Apply
button to apply the key.
4. Now you may verify the features provided by the key. In the Status
section of the left hand frame, click Array and then click Information.
Check the items listed in the License Features row.
Performing the Express Setup Procedure
The Express Setup procedure establishes global configuration settings that enable
basic Array functionality. Changes made in this window will affect all radios. If
you are not using XMS or Mobilize to perform your initial configuration, please
see “Express Setup” on page 159. Also see “Zero-Touch Provisioning and
Ongoing Management” on page 69.
See Also
Zero-Touch Provisioning and Ongoing Management
Installation Prerequisites
Installation Workflow
Logging In
To Next Page
Loading...
Need help?
General
