Yamaha AR190 2021 - Boating with Passengers; Stopping the Boat Safely

Pre-operation checks
114
Push the blower switch to operate the blower
and ventilate the engine compartment for at
least 4 minutes.
Navigation and anchor lights checks
Make sure that the bow light and anchor light
operate properly.
The procedure for setting up the anchor light
varies according to the model. See the page
indicated below for your boat.
SX195 / SX190: See page 88.
TIP:
SX195 / SX190: Before operating the boat in
daylight hours after checking the navigation
and anchor lights, store the anchor light.
195S / AR195 / AR190
1 Bow light
2 Anchor light
SX195 / SX190
1 Bow light
2 Anchor light
To check the operation using the navigation
and anchor lights switch:
(1) Push the top of the navigation and an-
chor lights switch and check that the
bow light and anchor light come on.
1 Navigation and anchor lights switch
(2) Push the bottom of the navigation and
anchor lights switch and check that only
the anchor light comes on.
(3) Put the navigation and anchor lights
switch in the middle position and check
that the bow light and anchor light are
off.
Horn switch check
Push the horn switch and check that the horn
sounds.
1 Horn switch
1
2
1
2
HORNBILGENAV/ANC
CTSY
LIGHTS
1
HORNBILGENAV/ANC
CTSY
LIGHTS
1
SportsBoat_F4V12.book Page 114 Thursday, June 4, 2020 5:17 PM
Downloaded from ManualsNet.com search engine