Instrument operation
43
Docking light switch (195S)
Push this switch to turn on the docking lights
at the bow on the port and starboard sides of
the boat.
1 Docking light
Switch circuit breakers
The electrical circuit for each switch is pro-
tected by a circuit breaker. If the button pops
out, push it back in with your finger. If it pops
out again, ask a Yamaha Boat Dealer to in-
spect the electrical system.
1 Switch circuit breaker
1 Switch circuit breaker
No-wake mode / cruise assist switch
This switch activates and sets the no-wake
mode, cruise assist, and reverse RPM con-
trol.
1 No-wake mode / cruise assist switch
To operate the no-wake mode and cruise as-
sist, see the following sections. To activate
the reverse RPM control, see “Reverse RPM
control” on page 45.
Operating the boat with a minimal wake
(no-wake mode)
The no-wake mode is useful for operating the
boat at a steady speed with a minimal wake.
This is especially convenient when traveling
in harbors, channels, or other areas posted
with low speed limits as “no wake zones”.
HORNBILGENAV/ANC
CTSY
LIGHTS
1111
HORNBILGENAV/ANC
CTSY
LIGHTS
1
SportsBoat_F4V12.book Page 43 Thursday, June 4, 2020 5:17 PM
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
