Yamaha AR190 2021 - Cruise Assist Operation

Instrument operation
44
The no-wake mode can be used only when
the engine is operating at idle speed.
To activate the no-wake mode:
(1) Put the remote control lever in the TDE
position or forward position so that the
engine is operating at idle speed.
(2) Push the plus side of the no-wake
mode / cruise assist switch. Once “No
Wake” or “No Wake Mode” is displayed
in the multifunction meter, the no-wake
mode is activated.
195S
AR195 / SX195 / AR190 / SX190
TIP:
The no-wake mode can be set to 3 engine
speeds. To adjust the engine speed while the
no-wake mode is activated, push the plus
side or minus side of the no-wake mode/
cruise assist switch.
To deactivate the no-wake mode:
Perform one of the following operations.
 Push the minus side of the no-wake mode /
cruise assist switch until “No Wake” or “No
Wake Mode” disappears.
 Push the remote control lever forward to
open the throttle.
Operating the boat at a steady speed
(cruise assist)
The cruise assist feature is for steady engine
speed operation when the boat is traveling
above no-wake speeds. The cruise assist is
available for use whenever the engine is run-
ning above 3000 rpm and below 7000 rpm.
To activate the cruise assist:
(1) Push the remote control lever forward to
open the throttle until the desired engine
speed is reached.
(2) Push the plus side or minus side of the
no-wake mode/cruise assist switch.
Once “Cruise” and the cruise assist setting
level are displayed in the multifunction dis-
play, the cruise assist is activated.
195S
1 Cruise assist setting level
NNW NE
SPEED
MPH
No Wake
am10:27
FUEL
100
%
Depth
9
ft
12.3V
1350
RPM
MPH
0
No Wake Mode
0.3 Avg MPG
NNW NE
SPEED
MPH
Cruise +4
1
SportsBoat_F4V12.book Page 44 Thursday, June 4, 2020 5:17 PM
Downloaded from ManualsNet.com search engine