Yamaha e60hmhd - Propeller Shaft Housing Assembly Removal; Propeller Shaft Housing Removal

PROPELLER SHAFT HOUSING ASSEMBLY
E
REMOVING THE PROPELLER SHAFT
HOUSING ASSEMBLY
1. Straighten:
• Claw washer tabs
2. Remove:
• Ring nut
• Claw washer
NOTE:
To remove the ring nut, straighten the lobe of
the claw washer by using a screwdriver, then
attach and turn it in the direction of the off
mark using the special service tool.
REMOVING THE PROPELLER SHAFT
HOUSING
1. Remove:
• Propeller shaft housing assembly
A For USA and CANADA
B Except for USA and CANADA
Ring nut wrench:
YB-34447/90890-06511..........
1
Ring nut wrench extension:
YB-06513/90890-06513..........
2
Propeller shaft housing puller:
YB-06234................................
1
Universal puller:
YB-06117................................
2
Propeller shaft housing puller:
90890-06503...........................
3
Stopper guide plate:
90890-06501...........................
4
Center bolt:
90890-06504...........................
5
A
B
6-13