Yamaha e60hmhd - Checking the Brush Holder; Checking the Cover

STARTER MOTOR
E
3. Check:
• Commutator under cut
Clog/dirty ➔ Clean.
NOTE:
Remove all particle metal by compressed air.
4. Check:
• Armature coil continuity
Out of specification ➔ Replace.
CHECKING THE BRUSH HOLDER
1. Measure:
• Brush length
a
Out of specification ➔ Replace.
2. Check:
• Brush holder continuity
Out of specification ➔ Replace.
CHECKING THE COVER
Measure:
• Cover bushing
Wear/damage ➔ Replace
Armature coil continuity
Commutator segments Continuity
Segment - Laminations No Continuity
Segment - Shaft No Continuity
Brush holder continuity
Brush holder
1
- Base
No Continuity
Brush length limit:
9.0 mm (0.35 in)
8-20