STEERING HANDLE ASSEMBLY
E
INSTALLING THE THROTTLE CABLE
Install:
• Throttle lever housing 1
• Throttle lever 2
• Throttle lever cover 3
• Throttle cable 4
Installing steps:
(1)Align stamped ark
a
on throttle lever 2
with the notch in throttle lever housing
1.
(2)Align the tip of throttle cable 4 with the
stamped mark on throttle lever 2, the
rotate throtle lever 2 counterclockwise
and wind throttle cable 4 inside throt-
tle lever housing 1.
(3)Secure throttle cable 4 to throttle cover
3.
INSTALLING THE SHIFT HANDLE
Install:
• Spring 1
•Ball 2
• Ball holder 3
NOTE:
Install ball holder 3 so that the machined
ball stopper on the inside is at the top.
7-11
To Next Page
