Yamaha F200B - Page 495

9-20
9
Disassembling the upper case
1. Remove the engine oil drain bolt 1,
cover 2, and damper 3.
2. Remove the bolts 4 and 5 and PCV 6,
and then remove the oil pan assembly
a.
3. Remove the circlip 7, and then remove
the bushing 8.
Checking the drive shaft bushing
1. Check the drive shaft bushing. Replace if
cracked or worn.
Checking the PCV
1. Check the PCV. Replace if cracked or
damaged.
Assembling the upper case
Do not reuse a gasket, always replace it
with a new one.
1. Install the bushing 1, and then install the
circlip 2.
2. Install the rubber seal 5 into the upper
case.
TIP:
Face the “” mark a on the rubber seal 5
up.
1
2
3
4
4
4
5
5
a
6
7
8
9
0
0
A
Bearing puller assembly 9: 90890-06535
Stopper guide stand 0: 90890-06538
Stopper guide plate A: 90890-06501
Needle bearing attachment 3:
90890-06653
Driver rod L3 4: 90890-06652
1
2
1
3
4
3
5
a
Upper case