Yamaha RX5 - Page 5

PREC IONS
EFFECTS ON OTHER ELECTRONIC
EQUIPMENT
e Avoid placing the RX5 in locations exposed to direct sunlight or high temperatures,
excessively high or low humidity, high dust concentration, or vibration. | . 2. 2. 2. | .
e Be sure to connect the RX5 to an AC power supply that meets the power supply Since this unit incorporates digital circuitry, simultaneous use ol other equipment such as
specifications listed on the accompanying PA-1210 12-volt power supply convertor. TVs, radios, elc. in close proximity may cause noise and erroneous operation. If this
®
If
there
is
any
danger
of
lightning
occurring
nearby,
turn
the
RX5
off,
remove
the
occurs,
separate
the
affected
units
sufficiently
to
eliminate
the
problem.
It
is
also
а
good
power plug from the wall socket in advance. idea to use separate line filters on each piece of equipment
e Be sure to make all connections properly, as shown in the REAR PANEL/
CONNECTIONS section.
è To avoid damaging your speakers and other playback equipment, turn off the power
ot all related equipment before making connections.
* Do not use excessive force in handling control switches and knobs.
* To avoid broken cords and short circuits, be sure to unplug all connectors by
grasping the respective plugs — NOT the cords.
e Remove the power plug from the AC mains socket if the unitis not to be used for an
extended period of time.
* Remove all plugs and connections if the unit is to be transported, to prevent damage
to the cords and jacks.
* Do not use solvents or paint thinners to clean the unit. Do not use insecticides or
other pressurized spray products in proximity to the unit. Wipe off the exterior using
a mild detergent on a cloth, then dry with a soft cloth.