P
Parameter Range Setting Error ..................... 145
Parameter Setting Range Error ..................... 129
Parameter Settings ..................................83
PASS ........................................129, 143
Password 1 ....................................... 211
Password 2 ....................................... 211
Password Settings ................................ 117
Peak Hold Current ............................111, 233
Peripheral Devices Affected by Drive Operation .... 157
PF ...........................................128, 138
Phase Order Selection............................. 212
Poor Speed Control Accuracy...................... 153
Power Specifications 200 V Class Models .......... 199
Power Specifications 400 V Class Models .......... 201
Previous Fault ................................110, 233
Programming Mode..........................79, 81, 82
Protective Covers, Reattaching..................... 195
Protective Covers, Removing ...................44, 194
PWM Feedback Data Fault ........................ 128
PWM Feedback Fault ............................. 132
R
RAM Fault ...................................128, 131
Ramp to Stop.......................................92
Rated Frequency..............................199, 201
Rated Output Capacity (kVA) ..................... 199
Rated Voltage ................................199, 201
REMOTE ..........................................85
Replacement Parts ................................ 207
Restart Enabled................................... 222
Reverse Direction................................. 222
Reverse Operation Selection ....................... 212
Reverse Run Command (2-Wire sequence) ......... 221
rH ...........................................128, 138
RTS Control Selection ............................ 224
Run command ......................................93
Run Command/Frequency Reference Source Selection
Error............................................. 146
Run Command at Power Up ....................... 212
Run Command Input Error ........................ 129
Run Command Input Selection.......................90
Run Command Selection ......................150, 212
Run Command Selection during Program........... 212
Run Command Selection Error..................... 129
S
S1 .................................................91
S2 .................................................91
Safety Hazard Definitions ...........................11
Safety Information ..................................11
S-Curve Characteristic at Accel End................ 214
S-Curve Characteristic at Accel Start ............... 214
S-Curve Characteristic at Decel End................ 214
S-Curve Characteristic at Decel Start ............... 214
S-Curve Characteristics ........................94, 126
SE ...........................................129, 143
Serial Communication Reference Selection ......... 220
Serial Communication Transmission Error ......129, 140
Setup Mode .................................... 81, 86
Shielded Twisted-Pair Cables........................57
Side-by-Side Setup .................................31
Sinking/Sourcing Mode Switch ......................24
Slip Compensation Gain........................... 214
Slip Compensation Primary Delay Time ............ 214
Soft Charge Circuit Fault .......................... 128
Soft CLA Selection ............................... 228
Software No. (Flash) .............................. 232
Software No. (ROM).............................. 232
Software Number (Flash).......................... 110
Software Number (ROM) ......................... 110
Speed Agreement Detection Level ................. 226
Speed Search ..................................... 222
Stall Prevention................................... 126
Stall Prevention During Deceleration ............65, 136
Stall Prevention Level during Acceleration ......... 226
Stall Prevention Level during Run ................. 226
Stall Prevention Selection during Acceleration ...... 226
Stall Prevention Selection during Deceleration ...... 226
Stall Prevention Selection during Run .............. 226
Standard Connection Diagram ................... 39, 40
STOP Key Function Selection ..................... 229
Stopping Method ...................................92
Stopping Method After Communication Error....... 224
T
Terminal A1 Bias Setting.......................... 222
Terminal A1 Gain Setting ......................... 222
Terminal A1 Input Voltage ........................ 110
Terminal A1 Signal Level Selection ................ 222
Terminal Block Configuration .......................43
Index
YASKAWA ELECTRIC TOEP C710606 26B YASKAWA AC Drive – J1000 Quick Start Guide
261
To Next Page
Loading...
