YASKAWA GA800

Startup Procedure and Test Run
6
6.6 Keypad Operation
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 477
9. Push or to select the hour or minute, then push or to change the value.
10. When you are done setting the time, push .
The procedure for setting the date and time is complete.
◆ Set Parameters Using the Setup Wizard
The Setup Wizard lets users follow simple messages on the keypad to set these basic parameters:
• Frequency Reference Source
• Input signal level
• Run command source
• Duty Rating
• Motor type
• Control Method Selection
• Maximum frequency
• Input/output settings
Note:
The Setup Wizard function will initialize all parameters before it sets the basic parameters.
1. Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push [Back] to show [Home] on .
2. Push [Menu].
3. Push or to select [Initial Setup], then push .