1. Log in to the WBM as an administrator.
2.
Navigate to ‘Security è Firewall’.
ð
The configuration page for the firewall is opened.
Firewall
Security
Security
Certificate Authentication
Firewall
SD Card
Syslog Configuration
User Authentication
Information
Diagnostics
Configuration
Administration
iC92...
PMC92...
n The changed firewall settings are transferred to the CPU with the [Apply] button.
n With the [Discard] button the settings made are discarded after a security query and
the WBM page is reloaded.
Messages regarding the transfer of firewall settings to the CPU are shown at ‘System
Message’ . The following system messages can occur:
n Status = OK
– The configured firewall settings were successfully transferred to the CPU.
n Warning
– The CPU reports a warning, e.g. if one or more additional filter configurations in
the system exist. The warning contains the names of all additionally loaded filter
tables.
n Error
– At least one firewall configuration is incorrect.
n When the firewall is enabled, you can use the [Show Rules] button to show an over-
view of all enabled firewall rules as a txt file.
n With [Save to File] you can save the file locally on your PC as a txt file.
At ‘General Configuration’ you can see the current firewall status and set it temporarily or
permanently.
Accessing the firewall
[Apply] and [Discard]
‘System Message’
‘System Status’
‘General Configuration’
iC9200 Series
Deployment
Web-based management - WBM > Security
HB700 | CPU | PMC921xEx | en | 23-06 96
To Next Page
Loading...
