Product Model EU Directive Harmonized Standards
n SGM7M
n SGM7J
n SGM7A
n SGM7P
n SGM7G
EMC Directive
2014/30/EU
EN 55011 group 1, class A
EN 61000-6-2
EN 61000-6-4
EN 61800-3 (Category C2,
Second environment)
Low Voltage Direc-
tive 2014/35/EU
EN 60034-1
EN 60034-5
RoHS Directive
2011/65/EU
EN 50581
Direct Drive
Servomotors
n SGM7E
n SGM7F
n SGMCV
n SGMCS
-B,
-C,
-D, and
-E
(Small-
Capacity,
Coreless
Servomo-
tors)
*1
EMC Directive
2014/30/EU
EN 55011 group 1, class A
EN 61000-6-2
EN 61000-6-4
EN 61800-3 (Category C2,
Second environment)
Low Voltage Direc-
tive 2014/35/EU
EN 60034-1
EN 60034-5
RoHS Directive
2011/65/EU
EN 50581
Linear Servo-
motors
n SGLG
*2
n SGLF
*2
n SGLF2
n SGLT
*2
EMC Directive
2014/30/EU
EN 55011 group 1, class A
EN 61000-6-2
EN 61000-6-4
EN 61800-3 (Category C2,
Second environment)
Low Voltage Direc-
tive 2014/35/EU
EN 60034-1
RoHS Directive
2011/65/EU
EN 50581
*1. Only models with “-E” at the end of model numbers are in compliance
with the standards. Estimates are available for those models. Contact
your Yaskawa representative for details.
*2. For Moving Coils, only models with “-E” at the end of model numbers
are in compliance with the standards.
– We declared the CE Marking based on the harmonized standards in
the above table.
– These products are for industrial use. In home environments, these
products may cause electromagnetic interference and additional
noise reduction measures may be necessary.
– Because SERVOPACKs and servomotors are built into machines,
certification is required after installation in the final product.
– Applicable when the Feedback Option Module is attached to SERVO-
PACKs for the command option attachable type.
Sigma-5 and Sigma-7 Series SERVOPACKs
General
Compliance with UL Standards, EU Directives, and Other Safety Standards
| | Feedback Option Module Type 3 - Manual version C - Revision 0 | en | 18