YASKAWA SGMAH - JOG Speed

Sigma II User’s Manual Chapter 5: Parameter Settings and Functions
5-52
5.3.2 JOG Speed
Use the following parameter to set or modify motor speed when operating the
servomotor from a panel or digital operator.
Use this parameter to set the motor speed when operating the servomotor from a
panel or digital operator. If the setting is higher than the maximum motor speed of
the servomotor, then the servomotor will rotate at its maximum speed.
Parameter Signal
Setting
(rpm)
Description
Pn304 JOG Speed
Setting Range: 0 to 10000
Default Setting: 500
Speed/Torque Control,
Position Control
Di
g
ital O
p
erator
SGDH-
MODE/SET DATA/
CHARGE
POWER
SERVOPACK
200V
YASKAWA
Panel O
p
erator