YASKAWA SGMAH - Operation in Monitor Mode

Sigma II User’s Manual Chapter 7: Using the Digital Operator
7 - 14
7. Press the DATA/SHIFT key once more for a minimum of one second to return
to the parameter number display.
This has changed the 1 digit of parameter Pn000 to “1”.
7.1.7 Operation in Monitor Mode
The Monitor Mode can be used for monitoring the reference values, I/O signal
status, and servo amplifier internal status.
The monitor mode can be set during motor operation.
 Using the Monitor Mode
The example below shows how to display 1500, the contents of monitor number
Un000 when the Servomotor rotates at 1500rpm.
Example With the Hand-held Digital Operator
1. Press the DSPL/SET key to select the monitor mode.
2. Press the Up Arrow or Down Arrow key to select the monitor number to
be displayed.
3. Press the DATA/ENTER key to display the monitor number selected in the
above step 2.
4. Press the DATA/ENTER key once more to return to the monitor number
display.
With the Built-in Panel Operator
1. Press the MODE/SET key to select the monitor mode.
2. Press the Up Arrow or Down Arrow key to select the monitor number to
Data
SGDM-
MODE/SET DATA/
CHARGE POWER
SERVOPACK
200V
YASKAWA