YASKAWA SGMAH

Sigma II User’s Manual Chapter 7: Using the Digital Operator
7 - 3
7.1.2 Functions
The digital operator can be used for parameter settings, operating references, and
status displays.
This section provides information on the keys and their functions available from the
initial displays.
Key Name Function
RESET Key
Press this key to reset the servo
alarm
DSPL/SET Key
• Press this key to select the status
display mode, auxiliary function
mode, parameter setting mode, or
monitor mode.
• This key is used for data selection
in parameter setting mode
DATA/ENTER Key
Press this key to set each parameter
or display the set value of each
parameter.
Value
Change/
JOG Key
Up Arrow Key
Press this key to increase the set
value. This key is used as a forward
start key in JOG operation.
Down Arrow Key
Press this key to decrease the set
value. This key is used as a reverse
start key in JOG operation.
Digit
Select
Key
Right Arrow Key
• Press this key to select the digit to
be changed. The selected digit
flashes.
•Press the
Right Arrow key to shift
to the next digit on the right.
•Press the
Left Arrow key to shift
to the next digit on the left.
Left Arrow Key
SVON Key
Press this key to perform the JOG
operation with the digital operator.
ALARM
RESET
DSPL
SET
DATA
ENTER
JOG
SVON
SERVOPACK
ALARM
RESET
DIGITAL
OPERATOR
JUSP-OP02A-1
DSPL
SET
DATA
ENTER
JOG
SVON
YASKAWA