YASKAWA SGMAH - Page 219

Sigma II User’s Manual Chapter 5: Parameter Settings and Functions
5-135
4. Press Left or Right Cursor Key to select the digit. The enable digit blinks.
Press Up or Down Cursor Key to change the value.
Pressing Left or Right Cursor Key when the left-end or right-end digit is blinking displays another 5
digits.
Press Left Cursor Key when this digit blinks.
The upper 5 digits are displayed.
5.
Press Left or Right Cursor Key to select the digit. The enabled digit blinks.
Press Up or Down Cursor Key to change the value.
Pressing Left or Right Cursor Key when the left-end or right-end digit is blinking displays another
5 digits.
Press Right Cursor Key when this digit blinks.
The lower 5 digits are displayed.
Repeat the steps 4 and 5 to change the data.
6. When the data is set, press DATA/ENTER Key.
The set data blinks and will be saved.
Note: When the password setting (write prohibited setting) is enabled, the setting can be read only by pressing Left
or Right Cursor Key.