YASKAWA SGMAH - Page 445

Sigma II User’s Manual Appendix B: List of Parameters
B - 9
Pn002
Function Selection Application Switches
0
Speed Control
Option
(T-REF
Terminal
Allocation)
0 None.
0
1 Uses T-REF as an external torque limit input.
2 Uses T-REF as a torque feed-forward input.
3
Uses T-REF as an external torque limit input when
P-CL and N-CL are ON.
1
Torque Control
Option
(V-REF
Terminal
Allocation)
0 None.
0
1 Uses V-REF as an external speed limit input.
2
Absolute
Encoder Usage
0 Uses absolute encoder as an absolute encoder.
0
1 Uses absolute encoder as an incremental encoder.
3 Not used. 0
DO NOT CHANGE
(Turns OFF PG output for full-closed option card,
FC100)PG output is OFF if set to 1.
0
Pn003
Function Selection Application Switches
0
1
Analog
Monitor 1
Torque
Reference
Monitor
Analog
Monitor 2
Speed
Reference
Monitor
0 Motor speed: 1V/1000rpm. 2
1 Speed reference: 1V/1000rpm.
0
2 Torque reference: 1V/100%.
3 Position error: 0.05V/1 reference units.
4 Position error: 0.05V/100 reference units.
5
Reference pulse frequency (converted to rpm): 1V/
1000rpm.
6 Motor speed
× 4: 1V/250rpm.
7 Motor speed
× 8: 1V/125rpm.
8
Reserved parameter (Do not change.).
9
A
B
C
D
E
F
2 Not used. — — 0
3 Not used. — — 0
Pn10B
Gain Application Switches
0
Mode Switch
Selection
0
Uses internal torque reference as the condition (Level
setting: Pn10C).
0
1
Uses speed reference as the condition (Level
setting: Pn10D).
2
Uses acceleration as the condition (Level setting:
Pn10E).
3
Uses error pulse as the condition (Level setting:
Pn10F).
4 No mode switch function available.
1
Speed Loop
Control Method
0 PI control.
0
1 IP control.
2 Not used. 0 — 0
3 Reserved 0 to 2 Reserved parameter. (Do not change). 0
Parameter
Digit
Place
Name Setting Description
Default
Setting