YASKAWA SGMSS - Page 133

7 Operation
7.1.1 Digital Operator Operation
7-4
(2) Parameter Set
Operation Key Display Description
Display the main menu of the utility function mode, and select
the utility function Fn002.
Press the Key.
Then, the screen changes and shows switches to the execution
* If the screen does not change, and NO-OP is displayed in
the status display section, a write prohibited password has
been saved in Fn010. Clear the write prohibited password if
possible.
Press the Key or the Key to select the appropriate
parameter number digit.
Press the Key or the Key to change the digit
value.
Press the Key.
Cursor moves from the parameter number to the parameter
value.
Press the Key or the Key to select the appropriate
value digit.
Press the Key or the Key to change the digit
value.
Press the Key.
Returns to the main menu of the auxiliary function mode.
Note: 1. For more information on operating method, refer to the Σ-III series SGMS/SGDS Digital Operator
Instructions (Manual No. TOBP S800000 01).
2. Some parameters require the power supply to be turned OFF and then turned ON again to enable the func-
tion. See 10.1.1 List of Parameters for full listing.
BB -FUNCTION-
Fn001
Fn002
Fn003
Fn004
BB -JOG-
Pn304 = 00500
Un000 = 00000
Un002 = 00000
Un00D = 00000000
BB -JOG-
Pn403 = 08000
Un000 = 00000
Un002 = 00000
Un00D = 00000000
BB -JOG-
Pn403 = 08000
Un000 = 00000
Un002 = 00000
Un00D = 00000000
BB -JOG-
Pn403 = 00200
Un000 = 00000
Un002 = 00000
Un00D = 00000000
BB -FUNCTION-
Fn001
Fn002
Fn003
Fn004
SIEPS80000025.book 4 ページ ２００４年１０月２５日 月曜日 午前１１時５７分