YASKAWA Varispeed-606PC3 User Manual

t .
VS-606PC3 INVERTER MAIN
UNIT (Coht"d)
1
.6 .3 Test
Run
Method
POWER
SUPPLY
-o
INVERTER
606PC3
Run by digital
operator
(Standard setting of model with
digital operator)
This method is to operate
the
inverter by using the RUN (run
command)
key, etc . of the digital
operator .
Since this operation mode is
set at the factory prior
to
shipping,
operation can be performed only
by
main
circuit wiring .
For details of the operation
method, refer
to Section 2
"DIGITAL OPERATOR" begin-
ning on page 64 .
MOTOR
IM
The
inverter can be operated i n the following two ways .
The model with digital
operator is set to
"OPERATION
MODE BY DIGITAL OPERATOR" and the model
without digital operator (with indicating cover) is set to
Vr Li~ti 1 lkJll lV1kJliju- r'itkjj .Vl
% . .kill
1 1Xkjl_j

V 1 1
TERMINAL" prior to shipping .
Run by control circuit terminal input
(Standard setting of model with
indicating
cover)
This
method
is to operate
the
inverter by frequency setter or
operation switch connected to the
control circuit terminal .
To perform operation by
control circuit
terminal input
of the
model
with digital operator, change
the operation mode to
"OPERATION FROM CONTROL
CIRCUIT TERMINAL" (No .
01=0000) .
POWER
SUPPLY
INVERTER
606PC3
FWD
SIGNAL
REV
SIGNAL
FREQ .
SETTER
MOTOR
IM
Ujz
92

YASKAWA Varispeed-606PC3 Specifications

General

Brand	YASKAWA
Model	Varispeed-606PC3
Category	Inverter
Language	English