YASKAWA Varispeed-606PC3

1 . VS-606PC
3 INVERTER
MAIN
UNIT (Cont'd)
I
The values show a short-term average deceleration torque when the motor single-unit decelerates
from 60 Hz at the shortest distance

It ;s not a continuous regenerative torque
Average deceleration torque ;s changed by the motor loss

If the motor operates exceeding
the
base frequency, this
value
is reduced
When a large regenerative torque
is needed,
use an optional braking resistor
#
To select "automatic restart after
momentary
power loss," set the 1st
digit
of constant (No 46) to "1 "
Automatic restart is available for up to 1 second for models CIMR-PCUBOP? or less or
up
to 2
seconds for models CIMR-PCUB 1 P5 or greater
** Temperature during shipping (for short period)
Voltage Class 240 V Single-phase
InverterInverter Model
BOP 1 BOP2 BOP4 BOP? B 1 P5 B2P2 B3P?*
Operat,on Signal
Forwarc run/reverse run by separate commands
Fault Reset
Releases protection
while the function , s operating .
Multifunct ;on contact lIput . 3 of the following signals
Multifunction
ava,lable to select
a
External
fault,
-u
;t
, soeed command, jog operator, accel/decel
S Input Select on
Lime select, 3-wire sequence, externa ; baseblock, speed search
command
Pnoto-
Mi+t ;fu-ction contact output two of the following signals
coupler
ava , ;able to select (48 VDC, 50
mA
or less)
Opera -
Output
(During running output, zero speed, frequency agreement,
`n
tion
output frequency ? set value,
during overtorque detection,
etc )
o a
State
Poss ;bie to select these functions as
multifunction
outputs
o
Contact 1 NO/NC contact output (250 VAC 1 A, 30 VDC 1 A or !ess)
Output (Du r ing rte^^ .r
, g
output, zero speed, frequency agreement
output frequency > set value, duri^g overtorque detection, e ;c )
O The following sett,ng-up is avai!able frequency reference
oias/gait , , upper/lower frequency
limit
. DC inectior
braking
Built- ;n Funct-on
current ./time
at starting/stopping,
full-automatic torque
boost,
frequency meter cal ;prating gain, fault retry, prohib ;teC
frequency, S-curve accel/dece ; .
,, LED Status Displays contents at RUN/STOP and protective function
D,splay
operation
o
c
D Digital Operator
Displays set frequency, output frequency, output current,
0 .9
d , rect , on of rotat,on, and the fault status .
Analog Oitput
Analog output (0 to 10 VDC) Possible to select output
LL
Monitor
.
frequency or output curve-t
Protective Configuration
Enclosed wail-mounted type
(NEMA 1), water and oust
tight
type (NEMA4)
Method Cooling
NEMA 1
Self -coolie ,
Forced-cool
i ng
NEMA4
Self-cooing Forced-cooling
Mass
NEMA 1
49(22) 6 .6(3)
10 .6 (48) 110 (5)
;~
(xg)
NEMA4
66(3) 88(4)
124
(56) -
Arnb,ent Temperature
+14
to 104°F
(--10
to +40 1 C) (not
frozen)
Storage Temperature ** -4 to 140°F (-20 to +60'C)
o ~ Humidity 9096 RH or less (non condensing)
0
w
U
Vibrat,on
Up to 98 m/s 2 (1G) at less than 20 Hz, Up to 2 m/s 2 (0 2 G)
at 20 to 50Hz