YASKAWA Varispeed-606PC3 - Page 70

1' . VS-606PC3 INVERTER MAIN
UNIT
(Cont"d)
To select "automatic restart after momentary power loss," set the 1st d-get of constant
(No 46)
to
"1 "
Automatic restart is available for up to 1 second for models CIMF :-PCU40P7 or less or up to
2 seconds
for models CIMR-PCU41 P5 or greater
Temperature during shipping (for short period)
Voltage Class 460 V 3-phase
Inverter Model
CIMR-PCU
40P2 40P4 40F'7 41P5 42P2
43P7
Operation Signal Forward operation/Reverse operation by separate commands
Fault Reset Release protection while the function ;s operating
Multifunction
contact
input
.
3 of the following signals
Multifunction
available to select
Setting
External fault, multispeed command, log operation, accel/decel
Input Selection
time select, 3-wire sequence, external baseblock, speed search
command
Photo-
Multifunction contact output : two of the
following
signals
coupler
available to select . (48 VDC,50 mA or less)
v Opera-
Output
(During running output, zero speed, frequency agreement,
tion
OUtDUt frequency ? set val ue, during overto rq ue detection , etc )
° State
Possible to select these functions asmultifunction outputs _
a
Contact
1 NO/NC contact output (2' .50 VAC 1 A, 30 VDC 1 A or less)
v
0 Output
(During running
OUtDUt, zero speed,
frequency agreement,
output frequency ? set val ue, during overtorque detection, etc )
0
o The following setong-up is available frequency reference
bias/gain, upper/lower frequency
limit,
DC injection
braking
0 Built-in Function current/time at starting/stopoing, full-automatic torque
boost,
frequency meter calibrating gain, fault retry, prorhib ;tea
frequency, S-curve
accel/d
ece l
,, LED Status
Disp!ays contents at RUN/STOP and protective function
`°
a
Display
operation .
o Digital
Operator Displays set frequency,
output
frequency, output current,
o°
U
(Option)
d'rection of rotat* , on and the fault status .
Analog Output Analog output (0 to 10 VDC) . Possible to select output
Monitor frequency or ouraut current
Enclosed wall-mounted type (NEMA 1), water and dust tight
Protect,ve Configuration
type
(NEMA4)
NEMA 1 Self-cooling forced cooing
Cooling Method
NEMA4
Self-cooling
Forced
cooling
Mass Ib (k
g)
NEMA 1
44(2) 6
6 (3) 9 7 (4 4)T102(46)
NEMA4
57(26) 88
1 4)
124(56)
Ambient Temperature
+14 to 104° F (-10 to +40°C) (not frozen)
Storage Temperature #
-4 to 140° F (-20 to +60'C)
0
o
Humidity
9096 RH or le ss (non-condensing)
0a
cc o
Vibration
Uo to 98 m/s 2 (1G) at less than 20 Hz, Up to 2 m/s 2 (0 2G)
wv at 20 to 50 Hz