Yealink CP960 Skype for Business - Configuring the Static Ipv4 Address; Configuring the Static Ipv6 Address

Getting Started
33
step 2.
DHCP is configurable via web user interface at the path Network->Basic.
Configuring the Static IPv4 Address
To configure a static IPv4 address via phone user interface:
1. Tap More->Advanced (default password: admin) ->Network->WAN Port.
2. Select IPv4 or IPv4 & IPv6 from the pull-down list of IP Mode.
3. Tap IPv4.
4. Tap the Type field.
5. Select Static IP from the pull-down list of Type.
6. Enter the desired value in the IP Address, Subnet Mask, Gateway, Pri.DNS and Sec.DNS
field respectively.
7. Tap Save to accept the change.
The touch screen will prompt “Reboot now?”
8. Tap OK.
This configuration will take effect after a reboot.
Static IPv4 address is configurable via web user interface at the path Network->Basic.
Configuring the Static IPv6 Address
To configure a static IPv6 address via phone user interface:
1. Tap More->Advanced (default password: admin)->Network->WAN Port.